|
Assembly Instructions
1) Remove the filter
elements and parts from their protective packaging, checking
each item against the diagram. Wash
all parts in hot, soapy water and dry. Keep everything
clean as you assemble (wash hands).
2) Fit the
knob (1) onto the lid (2) by inserting the screw (3) up
through the hole in the lid and screwing on the knob.
Hand tighten only. (only on the
SS4)
3) Place
the large sealing washer (10) over the threaded part of
the element (5).
4) Place
the element (5) into the hole in the base of the upper
chamber (4). Secure element in
the chamber base by screwing on the wing nut (11) onto
the threaded mount.
5) Repeat #3& #4 until all
elements have been installed.
6) Place
one small washer (8) onto the threaded part of the outlet
spigot (7). Insert thread of spigot
(7) through hole in the side of the lower chamber (6).
Place the second small washer (8) over the thread within
the chamber and secure in place with the nut (9). Tighten
securely by hand only.
7) Put the
upper chamber (4) onto the lower chamber (6) and place
lid (2) in position.
8) (only on the
LP5)
Place assembled unit on top of the base (included).
Operation
Ensure that the spigot (7) is in
the "OFF" position.
CONDITION FILTERS: Wash the ceramic
dust from the outer surfaces of the filter elements with
running, cold, water.
Fill upper chamber (4) fully with cold
or room temperature water and cover with lid (2).
Allow all water to gravity filter into
lower chamber. Open the spigot to allow all water to run
to waste.
Do this 4 or 5 times to completly clean the
filters of carbon "fines" and ceramic powder.
After completly cleaning the filters,
your Doulton is ready to use.
|
