| Assembly Instructions
1) Remove the filter elements and parts from
their protective packaging, checking each item against the diagram. Wash
all parts in hot, soapy water and dry. Keep everything clean as you assemble (wash
hands). 2) Fit the knob
(1) onto the lid (2) by inserting the screw (3) up through the hole in the lid
and screwing on the knob. Hand tighten only. (only on
the SS4) 3) Place
the large sealing washer (10) over the threaded part of the element (5). 4)
Place the element (5) into the hole in the base of the
upper chamber (4). Secure element in the chamber base by
screwing on the wing nut (11) onto the threaded mount.
5) Repeat #3& #4 until all elements have been installed. 6)
Place one small washer (8) onto the threaded part of the
outlet spigot (7). Insert thread of spigot (7) through
hole in the side of the lower chamber (6). Place the second small washer (8) over
the thread within the chamber and secure in place with the nut (9). Tighten securely
by hand only. 7) Put
the upper chamber (4) onto the lower chamber (6) and place lid (2) in position.
8) (only on the LP5)
Place assembled unit on top of the base (included). Operation
Ensure that the spigot (7) is in the "OFF" position.
CONDITION FILTERS: Wash the ceramic dust from the outer
surfaces of the filter elements with running, cold, water.
Fill upper chamber (4) fully with cold or room temperature water and cover with
lid (2). Allow all water to gravity filter into lower
chamber. Open the spigot to allow all water to run to waste.
Do this 4 or 5 times to completly clean the
filters of carbon "fines"
and ceramic powder. After completly
cleaning the filters, your Doulton is ready to use. | 
